One of the pins on the USB port doesn’t make contact with the circuit board anymore. One of the soldering pads got lifted off of the circuit board and the trace between the pad and the circuit board got cracked. With naked eyes you cannot see what is wrong but if you look under a microscope, you can see the problem right away. If you look at the drive from the side you can clearly see the USB port not being straight and bent upwards. That is a cheap drive but the data on it is priceless. ![]() Right after the accident the flash drive stopped being detected by any computer. ![]() Someone bumped into this USB flash drive while it was plugged in. Hakko FX-951 soldering station with T15-J02 tip. ![]() Tools and supplies I used for this repair:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |